Project

General

Profile

Actions
Copy link

Bug #1903

closed

1.x->2.0 Config upgrade problem with multiple bridged interfaces

Added by Chris Buechler over 12 years ago. Updated over 8 years ago.

Status:
Closed
Priority:
Low
Assignee:
-
Category:
Configuration Upgrade
Target version:
-
Start date:
09/26/2011
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
2.0
Affected Architecture:

Description

If you have OPT1 bridged to LAN, and OPT2 bridged to LAN, in 1.2.3 you have a single if_bridge interface with OPT1, OPT2 and LAN. After upgrading that scenario, you have two if_bridge interfaces. LAN and OPT1 plus LAN and OPT2. It should just be one bridge containing LAN, OPT1 and OPT2. The way it converts currently will break at least some scenarios where multiple interfaces are bridged.

Work around: delete the additional bridges, then edit the first bridge and select all the interfaces.

Actions
Copy link
 #1

Updated by Chris Buechler over 12 years ago

  • Priority changed from Normal to High
  • Target version deleted (2.0.1)
Actions
Copy link
 #2

Updated by Chris Buechler over 8 years ago

  • Subject changed from Config upgrade problem with multiple bridged interfaces to 1.x->2.0 Config upgrade problem with multiple bridged interfaces
  • Status changed from New to Closed
  • Priority changed from High to Low

this turned out to be an uncommon circumstance and nearly every impacted system is upgraded past this being an issue at this point.

Actions
Copy link

Also available in: Atom PDF