Project

General

Profile

Actions

Todo #7411

open

LADVD Devices not wide enough

Added by Andy Kniveton about 7 years ago. Updated over 6 years ago.

Status:
New
Priority:
Low
Assignee:
-
Category:
ladvd
Target version:
-
Start date:
03/20/2017
Due date:
% Done:

0%

Estimated time:
Plus Target Version:

Description

The output is when run from a shell is fine , but the output is cut off via the web gui in the top section :-

GUI

Capability Codes:
r - Repeater, B - Bridge, H - Host, R - Router, S - Switch,
W - WLAN Access Point, C - DOCSIS Device, T - Telephone, O - Other

Device ID Local Intf Proto Hold-time Capability Port ID
switch-1 igb0 LLDP 103 B gigabiteth

Shell

[2.3.3-RELEASE][admin@pfsense]/usr/local/sbin: ladvdc
Capability Codes:
r - Repeater, B - Bridge, H - Host, R - Router, S - Switch,
W - WLAN Access Point, C - DOCSIS Device, T - Telephone, O - Other

Device ID Local Intf Proto Hold-time Capability Port ID
switch-1 igb0 LLDP 98 B gigabitethernet1
[2.3.3-RELEASE][admin@pfsense]/usr/local/sbin: ladvdc -f
Chassis id: 60:38:e0:14:a2:b7
Port id: 60:38:e0:14:a2:b8
Time remaining: 95 seconds
Port Description: gigabitethernet1
System Name: switch-1
System Description: LGS308P 8-Port Gigabit PoE+ Smart Switch
System Capabilities: B
Enabled Capabilities: B
Management Address IPv4: 172.16.1.2
Port VLAN ID: 4093

[2.3.3-RELEASE][admin@pfsense]/usr/local/sbin:


Files

Untitled.png (106 KB) Untitled.png pfSense Andy Kniveton, 10/22/2017 04:57 AM
Untitled2.png (188 KB) Untitled2.png Wireshark Andy Kniveton, 10/22/2017 04:57 AM
Actions #1

Updated by Andy Kniveton about 7 years ago

Andy Kniveton wrote:

The output is when run from a shell is fine , but the output is cut off via the web gui in the top section :-

Damn my typing it should read :-

The output is fine when run from a shell, but the output is cut off via the web gui in the top section

Actions #2

Updated by Kill Bill over 6 years ago

Cannot see anything truncated here with current package in 2.4.x, plus the unformatted mess posted in the bug description doesn't help to put it mildly.

Actions #3

Updated by Andy Kniveton over 6 years ago

Sorry about the original post.

I've attached a few screenshots, 1 from pfSense and the other from Wireshark.

Oddly on my screenshot the Port ID shows two different values, the switch port missing "ernet1" from the end and a mac address in the detailed view.

Think I'll try and grab a Cisco switch and see what that looks like.

Actions

Also available in: Atom PDF