Bug #11651
closed
Error when adding both IPv4 and IPv6 P2 under an IPv4 or IPv6 only IKEv1 P1
0%
Description
GUI complains when adding both IPv4 and IPv6 P2 under a IPv4 or IPv6 only IKEv1 P1 (There is a Phase 2 using IPv6, cannot use IPv4.).
This is however perfectly fine to configure and use. P2 IP version is not in any way related to P1. This error is therefore spurious and should be removed.
Updated by Viktor Gurov almost 4 years ago
Updated by Jim Pingle almost 4 years ago
- Status changed from New to Pull Request Review
- Target version set to CE-Next
Updated by Jim Pingle almost 4 years ago
After the PR is merged this whole docs page can go away: https://docs.netgate.com/pfsense/en/latest/vpn/ipsec/ipv6.html
Updated by Renato Botelho almost 4 years ago
- Status changed from Pull Request Review to Feedback
- Assignee set to Viktor Gurov
PR has been merged. Thanks!
Updated by Jim Pingle over 3 years ago
Jim Pingle wrote:
After the PR is merged this whole docs page can go away: https://docs.netgate.com/pfsense/en/latest/vpn/ipsec/ipv6.html
The firewall info on there was good to keep, but I removed the top section which is no longer relevant:
https://gitlab.netgate.com/docs/pfSense-docs/-/commit/52330f178ef3a028a56a00f0e2c5a3a788d5f0b4
Updated by Jim Pingle over 3 years ago
- Target version changed from CE-Next to 2.6.0
Updated by Jim Pingle over 3 years ago
- Subject changed from WebGUI error when adding both IPv4 and IPv6 P2 under a IPv4 or IPv6 only IKEv1 P1 to Error when adding both IPv4 and IPv6 P2 under a IPv4 or IPv6 only IKEv1 P1
Updating subject for release notes.
Updated by Jim Pingle over 3 years ago
- Subject changed from Error when adding both IPv4 and IPv6 P2 under a IPv4 or IPv6 only IKEv1 P1 to Error when adding both IPv4 and IPv6 P2 under an IPv4 or IPv6 only IKEv1 P1
Updating subject for release notes.
Updated by Jim Pingle over 3 years ago
- Target version changed from 2.6.0 to 2.5.2