Actions
Bug #16274
closedUPnP IGD & PCP status page does not show "disabled" message after the service has been enabled then disabled
Start date:
Due date:
% Done:
100%
Estimated time:
Plus Target Version:
25.07
Release Notes:
Default
Affected Version:
Affected Architecture:
Description
The page at Status > UPnP IGD & PCP shows a "Service is currently disabled" message on a default/factory configuration. After the service has been enabled at least once then disabled, the status page no longer shows the message.
Files
Updated by Marcos M 3 months ago
- Status changed from New to Feedback
- % Done changed from 0 to 100
Applied in changeset 25901e7b0973a802ff02c725c566211f7f5ebe83.
Updated by Lev Prokofev 2 months ago
- File clipboard-202506210950-st6lr.png clipboard-202506210950-st6lr.png added
- File clipboard-202506210952-9cu9v.png clipboard-202506210952-9cu9v.png added
Can confirm this behavior,
Before the patch, after disabling the service:
After the patch:
Tested on 25.07.b.20250620
Updated by Christopher Cope 2 months ago
- Status changed from Feedback to Resolved
Tested on
25.11-DEVELOPMENT (amd64) built on Thu Jun 19 19:22:00 UTC 2025 FreeBSD 15.0-CURRENT
Working as expected. Marking resolved.
Updated by Jim Pingle about 2 months ago
- Target version set to 2.8.1
- Plus Target Version set to 25.07
Fixing target, commit was already in Plus 25.07 and CE 2.8.1 branches.
Updated by Jim Pingle about 2 months ago
- Subject changed from Status > UPnP IGD & PCP does not show disabled message after the service has been enabled then disabled to UPnP IGD & PCP status page does not show "disabled" message after the service has been enabled then disabled
Actions