Project

General

Profile

Actions

Bug #4046

closed

Invalid access-control.conf entry with certain IPv6 settings

Added by Anonymous about 10 years ago. Updated about 10 years ago.

Status:
Resolved
Priority:
Normal
Assignee:
-
Category:
DNS Resolver
Target version:
Start date:
11/25/2014
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
2.2
Affected Architecture:

Description

WAN connection with IPv6 via DHCP... when the box to request only a prefix is checked, this results in the WAN interface not having an IPv6 address. When the access-control.conf file for unbound is generated, it has the following invalid line:

access-control: / allow

This prevents unbound from being able to start.

Resolver log entries:
Nov 25 19:15:29 unbound: [88622:0] error: cannot parse netblock: '/'
Nov 25 19:15:29 unbound: [88622:0] error: cannot parse access control: / allow
Nov 25 19:15:29 unbound: [88622:0] fatal error: Could not setup access control list

Actions #1

Updated by Chris Buechler about 10 years ago

  • Status changed from New to Feedback
  • Target version set to 2.2
  • Affected Version set to 2.2

I don't see any way it's possible for that to happen unless you're on an old version. Every part of the code that puts in access-control lines that I can find does a check if it's an IP before putting it in the config. It didn't originally, that was fixed on the 17th.

Actions #2

Updated by Anonymous about 10 years ago

I was on a build dated 11/25. It doesn't seem to be a problem on a newer build now, so it must have been something that I did that caused it to happen. Not sure what though. Go ahead and close it since it seems to be working for me now.

Actions #3

Updated by Chris Buechler about 10 years ago

  • Status changed from Feedback to Resolved
Actions

Also available in: Atom PDF