Feature #8598

Add IPsec identifiers to Status > IPsec

Added by James Dekker 11 months ago. Updated 10 months ago.

Web Interface
Target version:
Start date:
Due date:
% Done:


Estimated time:


Add the IPsec identifiers used in the IPsec configuration, on the Status > IPsec page.

Associated revisions

Revision 3c5f4441 (diff)
Added by Stephen Jones 10 months ago

Fixed #8598 Added IPsec ID to the table, Moved the disconnect button over to better fit the page, Also fixed the disconnect button and show child button for mobile clients


#1 Updated by Jim Thompson 11 months ago

  • Category set to Web Interface
  • Assignee set to Steve Beaver
  • Target version set to 2.4.4

#2 Updated by Steve Beaver 11 months ago

  • Assignee changed from Steve Beaver to Anonymous

#3 Updated by Anonymous 10 months ago

Implemented this. Also found issues with the buttons not lining up correctly for mobile clients. I included the fix for both in the same commit. I was only able to test mobile clients on my setup. Some other tests that would be good to try to make sure it didn't break anything are IKEv1, IKEv2 with split connections.

#4 Updated by Anonymous 10 months ago

  • Status changed from New to Feedback
  • % Done changed from 0 to 100

#5 Updated by Jim Pingle 10 months ago

  • Status changed from Feedback to Resolved

IPsec IDs show up and look correct in the tunnels I have configured.

#6 Updated by James Dekker 10 months ago

On 2.4.4.a.20180720.1408, IPsec IDs like con1000: #1 (phase one) and conn1000: #2 (phase two) show correctly on the Status > IPsec page. Looks good here.

Also available in: Atom PDF