Project

General

Profile

Actions

Bug #12178

open

WireGuard always shows 'Configuring WireGuard tunnels...done.' message on boot

Added by Viktor Gurov over 2 years ago. Updated about 1 year ago.

Status:
New
Priority:
Low
Assignee:
-
Category:
WireGuard
Target version:
-
Start date:
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Affected Version:
Affected Plus Version:
Affected Architecture:

Description

WireGuard pkg always shows "Configuring WireGuard Tunnels...done." on boot, whether any tunnels are configured or not:

Starting device manager (devd)...done.
Loading configuration......done.
Configuring WireGuard tunnels...done.
Updating configuration...done.
Checking config backups consistency...done.
Setting up extended sysctls...done.
Setting timezone...done.

Actions #1

Updated by Christian McDonald over 2 years ago

easy fix, I can get that into next release

Actions #2

Updated by Car F about 1 year ago

Have to hop on this. This message (Configuring WireGuard tunnels) shows up couple of minutes if the interface the WG tunnel is created on isn't available. The "skip" or "timeout" should be far shorter or the WAN interface should be configured first. My bootup on 6100 MAX:

Initializing.................. done.
Starting device manager (devd)...done.
Loading configuration......done.
Configuring WireGuard tunnels...done.
Updating configuration...done.
Checking config backups consistency...done.
Setting up extended sysctls...done.
Setting timezone...done.
Configuring loopback interface...done.
Starting syslog...done.
Starting Secure Shell Services...done.
Setting up interfaces microcode...done.
Configuring loopback interface...done.
Configuring VLAN interfaces...done.
Configuring 2_WAN_VDF interface...done.
Configuring 5_HOTSPOT interface...done.
Configuring VDSL_MODEM interface...done.
Configuring 3_WAN_VDSL interface...done.
Configuring IOT interface...done.
Configuring HUE interface...done.
Configuring HYPERV interface...done.
Configuring NXTCLD interface...done.
Configuring SFP_FIBER interface...done.
Configuring 6_WG_MANNI interface...done.
Configuring 4_LAN interface...done.
Configuring 1_WAN_FTTH interface...done.
Configuring CARP settings...done.
Syncing OpenVPN settings...done.
route: route has not been found
Configuring firewall.....0 addresses deleted.
.done.
Starting PFLOG...done.
Setting up gateway monitors...done.
Setting up static routes...done.
Setting up DNSs...
Starting DNS Resolver...done.
Synchronizing user settings...done.
Configuring CRON...done.
Bootstrapping clock...done.
Starting NTP Server...done.
Starting webConfigurator...done.
Starting DHCP service...done.
Starting DHCPv6 service...done.
Configuring firewall.....0 addresses deleted.
0 addresses deleted.
.done.
Configuring IPsec VPN... done
Starting SNMP daemon... done.
Generating RRD graphs...done.
Starting syslog...done.
Configuring filter for dynamic IPsec VPN hosts... done
Starting CRON... done.
Netgate pfSense Plus 22.05-RELEASE amd64 Wed Jun 22 18:56:13 UTC 2022
Bootup complete

Actions

Also available in: Atom PDF