Project

General

Profile

Actions
Copy link

Bug #12837

closed

ipv6 block Rule is set even after disabling

Added by Peter Lustig about 3 years ago. Updated about 3 years ago.

Status:
Rejected
Priority:
Normal
Assignee:
-
Category:
Unknown
Target version:
-
Start date:
02/01/2022
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Release Notes:
Default
Affected Version:
2.6.0
Affected Architecture:

Description

Good Day,

When disabling ipv6 block rule under System - Advanced - Networking even ipv6 is not possible (without pfctl -d) when setting an ipv6 any-any rule (also web access is not possible without pfctl -d command).

System / Firewall logs states e.g Block all IPv6 (1000000003) is still active. It seems as there is some bug in configuration.

This matches 2.5.2 and 2.6.0, perhabs because system is only ipv6 and not ipv4/ipv6 mixed use?

Actions
Copy link
 #1

Updated by Jim Pingle about 3 years ago

  • Status changed from New to Rejected
  • Priority changed from Urgent to Normal

I can't reproduce this. If the "Allow IPv6" box is checked, the rule in question is not present in the ruleset and is not active. If I uncheck the box to block IPv6, then the rule is there. I can switch back and forth multiple times and each time the ruleset is correct.

There may be some other problem with your setup preventing the ruleset from reloading, but the problem as described does not exist.

This site is not for support or diagnostic discussion.

For assistance in solving problems, please post on the Netgate Forum or the pfSense Subreddit .

See Reporting Issues with pfSense Software for more information.

Actions
Copy link

Also available in: Atom PDF