Bug #3848
closed
enabling schedule on 2.1.5 causes page fault
0%
Description
Since enabling a scheduled rule my 2.1.5 installation I am observing daily kernel crashes due to a page fault. The crash coincides with /etc/rc.filter_configure_sync cronjob.
Hardware is alix2d13 with internal 2.5" IDE (core dumps available).
Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0x8
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc0a45cc0
stack pointer = 0x28:0xe2ff678c
frame pointer = 0x28:0xe2ff67b0
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 11 (irq10: vr0)
trap number = 12
panic: page fault
cpuid = 0
Uptime: 43m40s
Updated by Chris Buechler almost 10 years ago
- Category set to Operating System
can you re-test this on 2.2 and report back? I haven't had any luck replicating this.
Updated by Ernst den Broeder almost 10 years ago
I have installed 2.2 beta built on Sat Nov 22 02:14:01 CST 2014 (nano bsd 4g, no vga) and will monitor it.
Updated by Ernst den Broeder almost 10 years ago
21 days and no page fault so far. I am updating to the latest build today and will continue to monitor.
Updated by Chris Buechler almost 10 years ago
- Status changed from New to Resolved
- Target version set to 2.2
- Affected Version set to All
multiple people have confirmed 2.2 fixes this issue.