Actions
Bug #7838
closed
NAT outbound source using alias always shows /32
Status:
Not a Bug
Priority:
Normal
Assignee:
-
Category:
-
Target version:
-
Start date:
09/04/2017
Due date:
% Done:
0%
Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
Affected Architecture:
All
Description
Using alias for NAT outbound source network which in our case is a /24 always shows /32 when you edit it again.
If you don't use alias and put in an IP it stays at /24.
What is used? /24 from alias or /32 on the page?
Updated by Jim Pingle over 6 years ago
- Status changed from New to Not a Bug
- Affected Version deleted (
2.3.4_1)
When you use an alias, the CIDR drop-down on the NAT page does nothing. Any subnet mask must be specified in a network type alias
Actions