pfSense bugtracker

07/06/2015

06:32 AM pfSense Bug #4326: Limiters on firewall rules where NAT applies drop all traffic

Like Ryan, I'm still seeing the issue after upgrading to 2.2.3. Adam Hirsch

02/08/2015

10:58 AM pfSense Bug #4326: Limiters on firewall rules where NAT applies drop all traffic

Nope! Stays at 0 throughout.... Adam Hirsch

02/04/2015

09:52 AM pfSense Bug #4326: Limiters on firewall rules where NAT applies drop all traffic

I can verify that turning off reply-to doesn't seem to make a difference, here:
The rule:... Adam Hirsch

01/29/2015

07:50 AM pfSense Bug #4326: Limiters on firewall rules where NAT applies drop all traffic

I suppose that's possible, although manually checking the box to disable the generated reply-to doesn't seem to chang... Adam Hirsch

01/28/2015

02:53 PM pfSense Bug #4326: Limiters on firewall rules where NAT applies drop all traffic

I'm seeing this when the limiter is applied to a filter on the WAN interface, but not the LAN interface. Odd. Adam Hirsch

01/27/2015

10:06 PM pfSense Bug #4326 (Resolved): Limiters on firewall rules where NAT applies drop all traffic

A PASS filter rule with In / Out limiters set will pass traffic until bandwidth in a limited direction hits the limit... Adam Hirsch

09:33 PM pfSense Bug #4325 (Resolved): GUI for limiter rules turns Gb/s into b/s

Steps to reproduce:
# Firewall -> Traffic Shaper -> Limiter
# Create new limiter with a memorable bandwidth. (In ... Adam Hirsch