pfSense bugtracker

07/30/2015

11:59 AM pfSense Bug #4896: Gateway group failover

I've tried back and forth to trigger the fault again, but it is a no show, which is both good and bad. :)
However ... Andreas Winge

03:53 AM pfSense Bug #4896: Gateway group failover

First of all i turned off Grown notifications (thought they were off). And the warnings disappeared. Thanks!
I tri... Andreas Winge

07/29/2015

03:25 PM pfSense Bug #4896: Gateway group failover

This might be a DNS related issue dues to the warning messages I get. So FYI I am using the DNS Resolver with these s... Andreas Winge

03:02 PM pfSense Bug #4896: Gateway group failover

First of all when I run /etc/rc.filter_configure_sync it outputs 16 of these:
Warning: dns_get_record(): DNS Query ... Andreas Winge

07/28/2015

11:29 PM pfSense Bug #4896: Gateway group failover

The gateway group with re0 and ppp0 still says " route-to { ( re0 x.x.x.x ) } " Andreas Winge

10:40 PM pfSense Bug #4896: Gateway group failover

My setup for the WAN looks like this:
ISP - switch - Pfsense
If I pull the cable between the ISP and the switch... Andreas Winge

10:25 PM pfSense Bug #4896: Gateway group failover

It shows:
Name: WAN
Gateway: Changes from GW IP to "Dynamic"
Monitor: GW IP
RTT: 0.5ms
Loss: Changes from 0% t... Andreas Winge

02:26 PM pfSense Bug #4896 (Not a Bug): Gateway group failover

Two WAN connections (re0 and ppp0).
The two gateways are in a gateway group (re0 as tier 1 and ppp0 as tier 2).
Rul... Andreas Winge

01/24/2015

04:43 AM pfSense Bug #4273 (Resolved): OpenVPN options route-nopull and route-noexec swapped

From the pfsense GUI:
Don't pull routes - Don't add or remove routes automatically. Instead pass routes to --route-u... Andreas Winge

06/11/2014

03:49 PM pfSense Bug #1107: mpd on AMD64 generates invalid checksums with NAT

When I look back at what I wrote and on the logs, I see that all NAT have the checksum error. But for some reason the... Andreas Winge