Project

General

Profile

Actions
Copy link

Bug #15015

open

Static routes not working

Added by Silviu Bajenaru 6 months ago. Updated 3 months ago.

Status:
New
Priority:
Urgent
Assignee:
-
Category:
Routing
Target version:
-
Start date:
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Release Notes:
Default
Affected Version:
2.7.1
Affected Architecture:
amd64

Description

Hello,

This morning I updated to PFSense 2.7.1 from 2.7.0. Now, I just tried to add a dynamic gateway and a static route. Unfortunately, the static route is not being added to the routing table. I restored the VM backup from this morning, before I updated, added the same gateway and static route and it was added to the routing table, and everything works fine.
I've set the priority to Urgent since this is quite bad for a router...?

More info about my setup: I've got three sites, let's call them A, B and C. There is an IPSec tunnel between A and B, and one between B and C. Both tunnels are set with Mode VTI. I've assigned the ipsec interfaces and set the gateways and routes:
Site A has a gateway set on the IPSec interface and a route for site C that uses that gateway.
Site B has two gateways (one for each IPSec tunnel) and the following routes:
  • route to site A via the IPSec interface - gateway - going to site A
  • route to site B via the IPSec interface - gateway - going to site B
    Site C has a gateway set on the IPSec interface and a route for site A that uses that gateway.
    Site A was updated this morning to PFSense 2.7.1, while Site C is running 2.7.0.
    Site A DOES NOT have the static routes added to the routing table.
    Site C does have the static routes added to the routing table.

Once I reverted Site A to 2.7.0, I did the same config again and the routes were added to the routing table.

Thank you.

Actions
Copy link

Also available in: Atom PDF