pfSense

status_wireless.php doesn't display anything, though list scan does:

1. ifconfig ath0_wlan2 list scan
   SSID/MESH ID BSSID CHAN RATE S:N INT CAPS
   cmb 00:50:7f:9a:fd:68 1 54M -92:-96 100 EPS MESHCONF MESHCONF HTCAP RSN WME

Also not sure why it's wlan2, it's the only wireless card in the system.

Interface config:

               <opt2>
                        <descr>OPT2</descr>
                        <if>ath0</if>
                        <wireless>
                                <standard>11b</standard>
                                <mode>bss</mode>
                                <protmode>off</protmode>
                                <ssid>asdfasdf</ssid>
                                <channel>0</channel>
                                <authmode></authmode>
                                <txpower>99</txpower>
                                <distance/>
                                <wpa>
                                        <macaddr_acl></macaddr_acl>
                                        <auth_algs>1</auth_algs>
                                        <wpa_mode>1</wpa_mode>
                                        <wpa_key_mgmt>WPA-PSK</wpa_key_mgmt>
                                        <wpa_pairwise>CCMP TKIP</wpa_pairwise>
                                        <wpa_group_rekey>60</wpa_group_rekey>
                                        <wpa_gmk_rekey>3600</wpa_gmk_rekey>
                                        <passphrase/>
                                        <ext_wpa_sw></ext_wpa_sw>
                                </wpa>
                                <wep>
                                </wep>
                        </wireless>
                        <enable/>
                        <spoofmac/>
                </opt2>