Bug #4046
closedInvalid access-control.conf entry with certain IPv6 settings
0%
Description
WAN connection with IPv6 via DHCP... when the box to request only a prefix is checked, this results in the WAN interface not having an IPv6 address. When the access-control.conf file for unbound is generated, it has the following invalid line:
access-control: / allow
This prevents unbound from being able to start.
Resolver log entries:
Nov 25 19:15:29 unbound: [88622:0] error: cannot parse netblock: '/'
Nov 25 19:15:29 unbound: [88622:0] error: cannot parse access control: / allow
Nov 25 19:15:29 unbound: [88622:0] fatal error: Could not setup access control list
Updated by Chris Buechler over 9 years ago
- Status changed from New to Feedback
- Target version set to 2.2
- Affected Version set to 2.2
I don't see any way it's possible for that to happen unless you're on an old version. Every part of the code that puts in access-control lines that I can find does a check if it's an IP before putting it in the config. It didn't originally, that was fixed on the 17th.
Updated by Anonymous over 9 years ago
I was on a build dated 11/25. It doesn't seem to be a problem on a newer build now, so it must have been something that I did that caused it to happen. Not sure what though. Go ahead and close it since it seems to be working for me now.
Updated by Chris Buechler over 9 years ago
- Status changed from Feedback to Resolved