Bug #4589
closed
ue0 Interface Not Available During Console Interface Configuration
Added by Andrew Westfall about 9 years ago.
Updated about 9 years ago.
Category:
Operating System
Affected Architecture:
amd64
Description
USB LTE Modems prompt the Console Interface Configuration wizard to run at the next system boot. During the configuration of the interfaces the interface ue0, that was available from within the pfSense webgui is not an accepted interface for the Console Interface Configuration wizard.
https://forum.pfsense.org/index.php?topic=91907.0
Files
Note: The ue0 interface was successfully setup through the webGUI and was passing traffic, after a system reboot the Console Interface Configuration wizard ran and wanted to setup all interfaces again as if they were never configured.
Screenshot of Console Interface Configuration wizard asking to configure all interfaces.
- Category changed from Console Menu to Operating System
- Status changed from New to Needs Patch
- Priority changed from Very High to Low
- Target version deleted (
2.2.2)
The USB device is a Verizon UML295, which is listed in the list of Known Working 4G Modems: https://doc.pfsense.org/index.php/Known_Working_3G-4G_Modems
Also, the instructions for setting up the 4G modem are incorrect an do not work.
This device apparently doesn't work. Could we get updated instructions on how to make it work?
Same results after changing the mode using the guide above.
The Pantech UML295 works fine when added through the webGUI. After a reboot it presents you with the Console Interface Configuration Wizard, which will not accept ue0 as an applicable interface. ue0 is the interface that was shown in the webGUI but is not accepted in the Console Interface Configuration Wizard.
Also available in: Atom
PDF