Search
Results (252)
- Bug #4992 (Not a Bug): Dynamic DNS broken in update to 2.2.4
- Further to the guy who reported bug #4990, I ... but there are 2 WAN links and 5 VLANs on it.
- Bug #4866 (Resolved): L2TP server are restarted after adding/modifying L2TP users (mpd.secret)
- Full daemon restart is useless since mpd read ... 192.168.221.1/32, Peer 192.168.221.128, Area 0.0.0.0 MTU mismatch detection:enabled Router ... OSPF not enabled on this interface </pre>
- Bug #4746 (Resolved): captive portal allowed hostnames not loaded into table at boot time
- Configure CP with one or more passthrough hos ... # ipfw -x 2 table all list ---table(0)--- 0.0.0.0/0 49 ---table(3)--- ---table(4)--- </pre> ... es correctly. Reboot and they're gone again.
- Bug #4704 (Resolved): IKEv2 to Cisco ASA won't bring up multiple P2 networks
- Setup is following: pFsense firewall - hav ... ible both on 2.2.2 and 2.2.3 dev from 10 May.
- Feature #4591 (New): IPSec Failover Support for IP Addresses instead of Dynamic DNS / Failover Group
- Allow for IPSec failover IP instead of using ... quickly you could still end up with downtime.
- Bug #4587 (Resolved): apinger doesnt come up ... is disabled and vpn monitoring is on on boot
- on the nanobsd alix, i have one wan and one v ... t it after boot after all gateways are online
- Bug #4564 (Resolved): DHCP WAN without an IP ... leset with NAT reflection and destination any
- If the following events happen, invalid rules ... an IP address (leaving the interface set to 0.0.0.0/8 while attempting to obtain an IP address) ... rom any to /8 port 81 -> 192.168.1.11 </pre>
- Bug #4558 (Resolved): DHCP traffic getting blocked with DHCP Relay enabled
- Essentially the same issue as Bug #3074 but f ... IPv4 when the same works just fine with IPv6.
- Bug #4504 (Resolved): Bring back local network SPD exclusions for IPsec
- On 2.1.x and before, exclusions were added to ... al tunnel that sends all traffic over IPsec (0.0.0.0/0 remote) or one that uses a summarized network remote (10.0.0.0/8 when the LAN is also a 10.x.x.x net). I ... nd make sure the other is targeted for 2.2.2.
- Bug #4326 (Resolved): Limiters on firewall rules where NAT applies drop all traffic
- A PASS filter rule with In / Out limiters set ... can still pass, but only in that direction.