Project

General

Profile

Actions
Copy link

Bug #1281

closed

"Easy Rule: Pass this traffic" applies to phy. device and not VLAN device with name LAN

Added by A B about 13 years ago. Updated about 13 years ago.

Status:
Closed
Priority:
Normal
Assignee:
-
Category:
-
Target version:
-
Start date:
02/14/2011
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
Affected Architecture:

Description

I setup a alix 2d2 box for some pfSense 2.0RC1 tests. Used image is pfSense-2.0-RC1-4g-i386-20110214-0324-nanobsd-upgrade.img.gz upgraded from pfSense-2.0-BETA5-4g-i386-20110211-0021-nanobsd-upgrade.img.gz.

My interface configuration is:

Welcome to pfSense 2.0-RC1-nanobsd (i386) on fw-test
WAN (wan)                 -> pppoe0     -> NONE (PPPoE)
  VLAN (lan)                -> vr1        -> 192.168.120.254
  WIFILAN (opt1)            -> ath0_wlan0 -> 192.168.12.253
  DMZ (opt2)                -> vr1_vlan10 -> 192.168.10.254
  PBX (opt3)                -> vr1_vlan11 -> 192.168.11.254
  LAN (opt4)                -> vr1_vlan12 -> 192.168.12.254
  WIFIGUEST (opt5)          -> ath0_wlan1 -> 192.168.13.254

I renamed the physical LAN interface on vr1 to VLAN. On this device I put some real vlan devices like you can see from the config above.

I did some ICMP tests from my HP ProCurve 1810G-8 switch where I configured a port to listen to the tagged vlan 10 and 12.
At the pfSense firewall log I found the correct blocked ICMP traffic.

If I click on "Easy Rule: Pass this traffic" at the firewall log to create a rule to pass the traffic on the vlan interface called LAN the rule is generated on my device called (the renamed LAN to VLAN interface) VLAN.

So did I misconfigure the interfaces or is it a renaming problem with physical LAN to name VLAN?

I expect that the rule is generated correct on my vlan named interface LAN and not on the initial (phy. vr1) LAN interface.

Actions
Copy link

Also available in: Atom PDF