Bug #14543
closed
minor issue installing 2.7 with ZFS, mouse required!
Added by Patrik Stahlman about 2 years ago.
Updated about 2 years ago.
Description
This is a rare corner case (IMHO) but perhaps a "bug" worth fixing.
I was going to install a fresh 2.7 with ZFS. Everything went well until I got to the ZFS Configuration screen. Here I could not select the single VirtIO Block Device that was presented; neither the tab key nor the arrow keys would move up to the single entry to be selected. I had to resort to finding and connecting a mouse to the pfSense to successfully select the device.
- Status changed from New to Incomplete
The installer has been tested on multiple platforms, including Proxmox VE, Microsoft Hyper-V, and VMware ESXi. If the issue was experienced in any of those, it's likely to be an issue outside of pfSense software. It sounds as if the keyboard was not detected.
This site is not for support or diagnostic discussion. For assistance in solving problems, please post on the Netgate Forum . See Reporting Issues with pfSense Software for more information.
Marcos M wrote in #note-1:
It sounds as if the keyboard was not detected.
The keyboard was detected and used throughout the installation which went well except for the one page I mentioned, the ZFS Configuration page which required a mouse.
The installation was not done in a virtualized environment but on regular hardware. I was downgrading from 23.05.1 to 2.7 to enable ZFS and then back up to 23.05.1 again. There's nothing wrong with the hardware used.
This was not a support request, it is a bug report. I would not waste time discussing issues on this platform.
- Status changed from Incomplete to Not a Bug
Also available in: Atom
PDF
Updated by 
Updated by 
Updated by