Bug #1696
closed
Panic when finishing setup wizard with PPPoE WAN
Added by Chris Buechler over 13 years ago.
Updated about 13 years ago.
Category:
Operating System
Description
By going through the setup wizard and changing the WAN type to PPPoE, or just changing the PPPoE username and password, after clicking reload at the end of the setup wizard the system will panic as shown in the attached.
Files
Does this happen on current snapshots? I can't reproduce this in a VM.
I can still replicate this. If the WAN is set to PPPoE and you run through the setup wizard leaving the same settings, it panics after reloading at the last step of the wizard.
I was finally able to reproduce this in a VM, even when the WAN was initially set for DHCP. Same panic message/backtrace.
- Status changed from New to Feedback
- % Done changed from 0 to 100
Applied in changeset commit:db74464bf6f980c5c5845d53624d4c6f1b139fa7.
- Status changed from New to Feedback
- Status changed from Feedback to New
Panic still happens even after a gitsync picking up these changes. First run through the wizard (going from DHCP to PPPoE) worked for me, second run that was PPPoE to start and ended PPPoE resulted in a crash.
After reboot, doing a single run again (PPPoE to PPPoE) still crashes.
- Status changed from New to Feedback
- Status changed from Feedback to Resolved
Also available in: Atom
PDF
Updated by 
Updated by 
Updated by Ermal Luçi 
