Bug #1837
closed
Problem with PPP and default gateway switching
Added by Chris Buechler about 13 years ago.
Updated almost 9 years ago.
Affected Architecture:
All
Description
Description of how to replicate:
when these conditions are met:
WAN is a PPPoE interface
OPT1 is a PPP interface (3G stick)
I reboot the system with WAN cable disconnected, but the 3G stick in place.
I use the "allow default gateway switching" option.
The system stabilizes with no default gateway in its routing table. ppp0 interface is up and have an IP address.
If I disconnect and reconnect the 3G, nothing changes.
If I reconnect the WAN cable, wait a little bit, and disconnect it, now default gateway will be on the PPP interface.
- Assignee set to Jim Pingle
- Affected Version changed from 2.0 to 2.2.x
- Affected Architecture All added
- Affected Architecture deleted (
This also seems to be a problem with both WANs are PPPoE. The system logs that it's switching the gateway during the initial transition but it never actually happens.
Eventually something will trigger the system to refresh the gateway and it comes back, such as loading a page in the GUI that touches gateway groups.
To me for more testing/evaluation.
- Status changed from New to Confirmed
- Affected Version changed from 2.2.x to All
- Status changed from Confirmed to Feedback
- % Done changed from 0 to 100
I believe I located the source of the trouble here. With "set iface route default" in the mpd config, it was removing the default route when the PPP link was lost even when it did not match what it put in place. I omitted that line and put a safety belt in ppp-linkdown to stop it from removing the gateway when it doesn't match.
I tested this with default gateway switching on and off, by rebooting, manually disconnecting the PPP link, and manually disconnecting the NIC link, worked each time, though still possible some issues remain. Feedback appreciated.
- Status changed from Feedback to Resolved
- Target version set to 2.3
Also available in: Atom
PDF
Updated by 
Updated by