Project

General

Profile

Actions

Feature #2850

closed

add units in ntp status page

Added by Kristoffer Øyjord over 11 years ago. Updated over 4 years ago.

Status:
Resolved
Priority:
Low
Category:
NTPD
Target version:
Start date:
03/02/2013
Due date:
% Done:

100%

Estimated time:
Plus Target Version:
Release Notes:

Description

Hi, I am trying to set up a stratum 1 ntp server with a serial gps (if that is what it is called)
and when I am checking the ntp status page, there is no units behind the numbers.

after figuring out that most of the page is the output of ntpq -p, and looking
up the man page online, I see that the polling interval is in seconds,
and delay, offset, jitter is in milliseconds.

It would be great if there was units behind the numbers (s,ms) for simplicity.

Actions #1

Updated by Chris Buechler over 11 years ago

  • Target version deleted (2.1)
  • Affected Version deleted (2.1)
Actions #2

Updated by Jim Pingle about 5 years ago

  • Category changed from Web Interface to NTPD
Actions #4

Updated by Jim Pingle over 4 years ago

  • Status changed from New to Pull Request Review
Actions #5

Updated by Renato Botelho over 4 years ago

  • Status changed from Pull Request Review to Feedback
  • Assignee set to Renato Botelho
  • Target version set to 2.5.0
  • % Done changed from 0 to 100

PR has been merged. Thanks!

Actions #6

Updated by Viktor Gurov over 4 years ago

  • Status changed from Feedback to Resolved

OK on 2.5.0.a.20200324.1145

Actions

Also available in: Atom PDF