Bug #7711
closed
Traffic Shapper = Kernel Panic
0%
Description
Hardware APU2C4 with SSD 16Gb
As soon as I configure traffic shapper (wizard or not), my pfsense is completely stuck with a kernel panic.
I have reinstall 2 times my system from scratch and it's the same issue at each time.
I can have ip but no webinterface and after that kernel panic...
At startup I can see this error :
Configuring firewall.route: writing to routing socket: No such process
.....done.
and 1 minute after the end of the boot :
Fatal trap 12: page fault while in kernel mode
cpuid = 2; apic id = 02
fault virtual address = 0x20071
fault code = supervisor write data, page not present
instruction pointer = 0x20:0xffffffff80d46037
stack pointer = 0x28:0xfffffe01210f9760
frame pointer = 0x28:0xfffffe01210f9790
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, long 1, def32 0, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 14034 (unbound)
Updated by Julien REVERT over 7 years ago
The stability of the APU2C4 was perfect for 5 months before traffic shapper testing...
Same issue with 3 other APU2C4 hardware...
Updated by Jim Pingle over 7 years ago
- Status changed from New to Rejected
- Priority changed from Urgent to Very Low
Please discuss the problem on the forum before opening a bug report.
It's entirely possible that even if it isn't a hardware fault, it's still a problem specific to your hardware. Most likely it's either the hardware or the drivers for your specific network chipset on that hardware, or some setting specific to your hardware that needs changed.
Updated by Julien REVERT over 7 years ago
Ok but APUC4 is a compatible pfsense hardware no?
Updated by Jim Pingle over 7 years ago
Like most other x86/x86-64 hardware, while it may work, we do not specifically test on that platform to ensure compatibility.
Updated by Julien REVERT over 7 years ago
Ok, I will do more testing and keep you inform.
Thanks.