Bug #12049
closed
Input validation incorrectly rejects a second IPv4-only GRE tunnel
Added by Peter Van Overveldt over 3 years ago.
Updated about 3 years ago.
Plus Target Version:
22.01
Description
More info:
-> This only occurs when creating A 2ND SUCH TUNNEL FOR THE SAME "Parent Interface"
-> The "GRE-tunnel-Creation-page I am referring to, is under Menu "Interfaces" -> "Assignements" -> GREs-tab -> "+ Add"
-> This was not the case in earlier versions of pfsense; we were able to define GRE-tunnels this way in the past just fine.
-> I got this error with version 2.5.1. 2.5.2 is indicated below, because 2.5.1 isn't selectable.
- Target version changed from 2.5.2 to CE-Next
This is not a regression. Too late for 2.5.2
- Status changed from New to Pull Request Review
- Target version changed from CE-Next to 2.6.0
- Plus Target Version set to 21.09
- Assignee set to Viktor Gurov
PR has been merged. Thanks!
- Status changed from Pull Request Review to Feedback
Tested in
21.09-DEVELOPMENT (amd64)
built on Sat Jul 17 01:10:40 EDT 2021
FreeBSD 12.2-STABLE
It works. I was able to successfully create two GRE tunnels with blank IPv6 addresses.
- Status changed from Feedback to Resolved
- Affected Version changed from 2.5.1 to 2.5.2
- Subject changed from GRE tunnels: attempt to create of an IPv4-only GRE-tunnel ( by leaving empty "Local IPv6 tunnel address." and "Remote IPv6 address address.") results in "A GRE tunnel with the same IPv6 tunnel network is already defined.". to Input validation incorrectly rejects a second IPv4-only GRE tunnel
- Category changed from Web Interface to Interfaces
Updating subject for release notes.
- Plus Target Version changed from 21.09 to 22.01
Also available in: Atom
PDF
Updated by 
Updated by Viktor Gurov 
Updated by 
Updated by