Project

General

Profile

Actions

Bug #13654

open

Wireguard does not fail back failover WAN setup.

Added by Frode Martin almost 2 years ago. Updated 4 months ago.

Status:
New
Priority:
Normal
Assignee:
-
Category:
WireGuard
Target version:
-
Start date:
Due date:
% Done:

0%

Estimated time:
Plus Target Version:
Affected Version:
Affected Plus Version:
24.03
Affected Architecture:
SG-1100

Description

I have this main WAN connection that is quite unstable. So I set up a 4G router on the OPT port on netgate 1100. This port is configured as a tier 2, and is only used if main WAN connection is down. This works great for ordinary traffic, but not for wireguard. Wireguard fails over to OPT-port OK when WAN connection goes down. But not back when WAN connection is up again. I have to disable and then enable the opt port to manually change interface for wireguard.

Wireguard version is 0.1.6_2.

Actions

Also available in: Atom PDF