Bug #1420
closed
Changing a WAN's type from PPPoE to other breaks it
Added by Chris Buechler over 13 years ago.
Updated over 9 years ago.
Description
When a WAN interface set for PPPoE is switched to any other type, it breaks it, as it leaves that interface assigned as pppoeX. It has to switch it back to the physical interface when the type is changed.
Should it delete the already created pppoe config?
probably, that would be consistent with 1.2.x
- Status changed from New to Feedback
Hello
I did some tests on my 2.0-RC1 (i386) built on Thu May 5 00:36:37 EDT 2011 NanoBSD config.
1. Setup PPPoE Interface on WAN.
2. Change the type to static.
3. Check the Interface Assignments and Interface Settings.
4. Check the config file in /conf/config.xml for PPPoE entry, none found.
-> Everything seems to be ok in my installation here.
Peter
- Status changed from Feedback to Resolved
I ran into this bug on a pfSense 2.2 box. Procedure to recreate was to do the following:
1. Setup PPPoE Interface on WAN
2. PPPoE connection works
Reconfigure from PPPoE to DHCP
1. Interface Assignments - WAN -> em0
2. PPPs -> Delete pppoe0
3. Interfaces -> WAN, change PPPoE to DHCP gets error, change PPPoE to static, Applied settings and no error
4. Rebooted and had to console into box and observed system asking to setup interfaces starting with VLANs
Also available in: Atom
PDF
Updated by Ermal Luçi 
Updated by 
Updated by 
Updated by