Bug #14288
closed
Setting system DNS servers can incorrectly modify routes for interface addresses
Added by Marcos M over 1 year ago.
Updated over 1 year ago.
Plus Target Version:
23.05.1
Description
Tested on 23.01
Using an address on lo0 (e.g. a localhost VIP or simply @127.0.0.1) as a DNS sever under System / General Setup results in a missing route for the specified address.
Example below after adding 127.0.0.1 (persists reboots):
[23.01-RELEASE][root@router.lab.arpa]/root: netstat -rn4
Routing tables
Internet:
Destination Gateway Flags Netif Expire
default 10.0.5.1 UGS vmx1
10.0.5.0/24 link#2 U vmx1
10.0.5.75 link#2 UHS lo0
172.19.0.0/20 192.0.2.4 UGS vmx2
192.0.2.0/28 link#3 U vmx2
192.0.2.1 link#3 UHS lo0
192.0.2.200/29 link#11 U vmx3.522
192.0.2.201 link#11 UHS lo0
192.0.2.240/28 link#9 U vmx3.521
192.0.2.241 link#9 UHS lo0
192.168.0.0/20 198.51.100.2 UGS vmx0
198.51.100.0/28 link#1 U vmx0
198.51.100.1 link#1 UHS lo0
- Description updated (diff)
- Description updated (diff)
- Affected Version set to 2.5.1
Some related discussion:
https://forum.netgate.com/topic/162791/
The issue was introduced in 2.5.1 with https://redmine.pfsense.org/issues/11578. The code removes the route when a gateway is not set for the DNS server. Since this process only deletes routes on localhost (routes for other interfaces remain), validation could be added to prevent localhost routes from being deleted. This should be an adequate solution given that a localhost gateway cannot be created and hence used in the DNS Servers option.
Note:
Due to this issue and https://redmine.pfsense.org/issues/12078, it's no longer possible to configure pfSense to use bind for its own DNS queries (e.g. update checks).
This impacted quite a few users at the time. It should at least be documented. I would prefer to see a note on the General Setup page to prevent foot shooting.
- Subject changed from Using a localhost address as a system DNS server prevents its route from being added to Setting system DNS servers can incorrectly modify routes for interface addresses
- Status changed from New to Pull Request Review
- Status changed from Pull Request Review to Feedback
- % Done changed from 0 to 100
- Target version set to 2.7.0
- Plus Target Version set to 23.05.1
- Status changed from Feedback to Resolved
Also available in: Atom
PDF
Updated by 
Updated by 
Updated by