Project

General

Profile

Actions
Copy link

Bug #8422

closed

Switching VLAN mode removes the switch port settings from the config.

Added by Steve Wheeler over 6 years ago. Updated over 6 years ago.

Status:
Resolved
Priority:
High
Assignee:
Luiz Souza
Category:
Interfaces
Target version:
2.4.4
Start date:
04/03/2018
Due date:
% Done:

100%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
2.4.3
Affected Architecture:
All

Description

On devices with a built in switch changing the switch VLAN mode removes the port state settings from the config resulting in all the ports set as disabled.

This applies when switching from port mode to .1q mode on a clean install or from .1q to port mode on a funtioning .1q setup.

Saving on the ports tab is sufficient to restore the port config which is then applied if rebooted.

Config after switching to .1q mode, adding a vlan and rebooting. From a clean install:

    <switches>
        <switch>
            <device>/dev/etherswitch0</device>
            <vlanmode>DOT1Q</vlanmode>
            <swports></swports>
            <vlangroups>
                <vlangroup>
                    <vgroup>1</vgroup>
                    <vlanid>100</vlanid>
                    <descr></descr>
                    <members>2</members>
                </vlangroup>
            </vlangroups>
        </switch>
    </switches>

After re-saving on the ports tab:

    <switches>
        <switch>
            <device>/dev/etherswitch0</device>
            <vlanmode>DOT1Q</vlanmode>
            <vlangroups>
                <vlangroup>
                    <vgroup>1</vgroup>
                    <vlanid>100</vlanid>
                    <descr></descr>
                    <members>2</members>
                </vlangroup>
            </vlangroups>
            <swports>
                <swport>
                    <port>1</port>
                    <pvid>1</pvid>
                    <state><![CDATA[forwarding]]></state>
                </swport>
                <swport>
                    <port>2</port>
                    <pvid>1</pvid>
                    <state><![CDATA[forwarding]]></state>
                </swport>
                <swport>
                    <port>3</port>
                    <pvid>1</pvid>
                    <state><![CDATA[forwarding]]></state>
                </swport>
                <swport>
                    <port>4</port>
                    <pvid>1</pvid>
                    <state><![CDATA[forwarding]]></state>
                </swport>
                <swport>
                    <port>5</port>
                    <pvid>1</pvid>
                    <state><![CDATA[forwarding]]></state>
                </swport>
            </swports>
        </switch>
    </switches>

Actions
Copy link

Also available in: Atom PDF