Feature #9111
closed
Add IPsec VTI interface MTU support
Added by Jim Pingle almost 6 years ago.
Updated over 4 years ago.
Description
Currently, IPsec VTI interfaces have no special handling for MTU. It is possible to nudge it manually after the system boots, but the settings are not retained/applied at boot time.
- Target version changed from 48 to 2.5.0
- Status changed from Assigned to Feedback
- % Done changed from 0 to 100
Verified MTU settings are stored and applied properly. Loogs good.
- Status changed from Feedback to Resolved
- Target version changed from 2.5.0 to 2.4.5
- Status changed from Resolved to Feedback
Needs checked and/or tested again on 2.4.5 snapshots
I applied this patch to my 2.4.4 machines. They have been running for a while without issue. When I change the MTU it gets applied, it survives across reboot.
- Status changed from Feedback to Resolved
VTI MTU is applied as expected and survives reboot on 2.4.5.a.20191220.0501
Also available in: Atom
PDF