Project

General

Profile

Actions

Feature #9111

closed

Add IPsec VTI interface MTU support

Added by Jim Pingle over 5 years ago. Updated over 4 years ago.

Status:
Resolved
Priority:
Low
Assignee:
Category:
IPsec
Target version:
Start date:
11/12/2018
Due date:
% Done:

100%

Estimated time:
Plus Target Version:
Release Notes:

Description

Currently, IPsec VTI interfaces have no special handling for MTU. It is possible to nudge it manually after the system boots, but the settings are not retained/applied at boot time.

Actions #1

Updated by Jim Pingle about 5 years ago

  • Target version changed from 48 to 2.5.0
Actions #2

Updated by Jim Pingle almost 5 years ago

  • Status changed from Assigned to Feedback
  • % Done changed from 0 to 100
Actions #3

Updated by Chris Linstruth over 4 years ago

Verified MTU settings are stored and applied properly. Loogs good.

Actions #4

Updated by Jim Pingle over 4 years ago

  • Status changed from Feedback to Resolved
Actions #5

Updated by Jim Pingle over 4 years ago

  • Target version changed from 2.5.0 to 2.4.5
Actions #6

Updated by Jim Pingle over 4 years ago

  • Status changed from Resolved to Feedback

Needs checked and/or tested again on 2.4.5 snapshots

Actions #7

Updated by Mix Room over 4 years ago

I applied this patch to my 2.4.4 machines. They have been running for a while without issue. When I change the MTU it gets applied, it survives across reboot.

Actions #8

Updated by Jim Pingle over 4 years ago

  • Status changed from Feedback to Resolved

VTI MTU is applied as expected and survives reboot on 2.4.5.a.20191220.0501

Actions

Also available in: Atom PDF