Project

General

Profile

Actions
Copy link

Bug #10383

closed

Additional interfaces do not survive a reboot before the setup wizard has been run

Added by Steve Wheeler over 4 years ago. Updated about 4 years ago.

Status:
Resolved
Priority:
Normal
Assignee:
Renato Botelho
Category:
Interfaces
Target version:
2.5.0
Start date:
03/28/2020
Due date:
% Done:

100%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
All
Affected Architecture:
All

Description

In a fresh install before the setup wizard has been run or dismissed the file /conf/trigger_initial_wizard exists.

Whilst that file exists if you enable additional interfaces and set IPs etc those changes will be lost at reboot.

Changes made to interfaces enabled by default, WAN and LAN usually, are retained.

It appears that something triggered by the existence of that file disables any interfaces that are not enabled in the default config.

See attached example from an XG-7100 running a clean install of 2.4.5.

Files

Eaxmple_XG- 7100.txt (20.6 KB) Eaxmple_XG- 7100.txt Steve Wheeler, 03/27/2020 08:29 PM
Actions
Copy link
 #1

Updated by Steve Wheeler over 4 years ago

This also happens if you restore a config from the CLI after defaulting. To regain access via other interfaces for example.

When you reboot into the new config the default interfaces are applied over the restored config.

Actions
Copy link
 #3

Updated by Jim Pingle over 4 years ago

  • Status changed from New to Pull Request Review
Actions
Copy link
 #4

Updated by Renato Botelho over 4 years ago

  • Status changed from Pull Request Review to Feedback
  • Assignee set to Renato Botelho
  • % Done changed from 0 to 100

PR has been merged. Thanks!

Actions
Copy link
 #5

Updated by Anonymous about 4 years ago

  • Status changed from Feedback to Resolved
Actions
Copy link

Also available in: Atom PDF