Added by Viktor Gurov almost 3 years ago. Updated over 2 years ago.
100%
Description
Instead of waiting for a packet loss threshold, the gateway must be marked as 'offline' on link down event
/etc/rc.linkup should be improved
Updated by Viktor Gurov almost 3 years ago
partially implemented in https://github.com/pfsense/pfsense/commit/da836151dbd6dff0f8759ef165b24e0e173b078e,
but it does not work with PPPoE
Updated by Viktor Gurov almost 3 years ago
Updated by Viktor Gurov almost 3 years ago
Updated by Jim Pingle almost 3 years ago
Updated by Viktor Gurov almost 3 years ago
Applied in changeset 13720b183efaf5697454978db93a5b4815227149.
Updated by Jim Pingle over 2 years ago
Updated by Alhusein Zawi over 2 years ago
GW is waiting for a packet loss threshold, it does not go to offline immediately.
tested by disabling PPPoE server.
client interface goes down (Status>Interfaces) but GW needs a few seconds to be in offline Status.
2.7.0.a.20220226.0600
Updated by Viktor Gurov over 2 years ago
Alhusein Zawi wrote in #note-8:
GW is waiting for a packet loss threshold, it does not go to offline immediately.
tested by disabling PPPoE server.
client interface goes down (Status>Interfaces) but GW needs a few seconds to be in offline Status.
2.7.0.a.20220226.0600
To test this fix, you need to disconnect the cord from the PPPoE-enabled interface on the hardware appliance
Updated by Danilo Zrenjanin over 2 years ago
Tested the patch:
22.05-DEVELOPMENT (arm64) built on Tue May 10 12:33:50 UTC 2022 FreeBSD 12.3-STABLE
After removing the cable on the PPPoE (WAN) interface, it didn't mark the gateway as offline immediately. Gateway monitoring was increasing the packet loss procent.
Please check again.
Updated by Viktor Gurov over 2 years ago
Danilo Zrenjanin wrote in #note-10:
Tested the patch:
[...]After removing the cable on the PPPoE (WAN) interface, it didn't mark the gateway as offline immediately. Gateway monitoring was increasing the packet loss procent.
Please check again.
That's true only for switchport interfaces.
For non-switchport interfaces it works as expected.
Updated by Danilo Zrenjanin over 2 years ago
I retested on the SG-5100 as a PPPoE client. It works as expected. After unplugging the cable from the PPPoE parent interface, the gateway status immediately goes pending.
I am marking this ticket resolved.