Project

General

Profile

Actions
Copy link

Bug #3665

closed

IPsec tunnel description not displayed on status output

Added by Jim Pingle over 10 years ago. Updated about 10 years ago.

Status:
Resolved
Priority:
Normal
Assignee:
Ermal Luçi
Category:
IPsec
Target version:
2.2
Start date:
05/16/2014
Due date:
% Done:

100%

Estimated time:
Plus Target Version:
Release Notes:
Affected Version:
2.2
Affected Architecture:
All

Description

The strongswan IPsec status output uses the internal name, e.g. conn2-2, and does not display the description entered by the user for the tunnel.

It would be very helpful to have that name displayed to save tracking down info and cross-referencing manually.

Actions
Copy link
 #1

Updated by Renato Botelho over 10 years ago

  • Status changed from New to Feedback
  • % Done changed from 0 to 100
Actions
Copy link
 #2

Updated by Jim Pingle over 10 years ago

Looks good to me. Might be nice to have the P2 descriptions in the Child SA list as well if it's not too much trouble.

Actions
Copy link
 #3

Updated by Chris Buechler over 10 years ago

  • Status changed from Feedback to New

This apparently regressed since then, the description is currently shown as "(730)" where 'ipsec status' output shows:

        con2[730]: ESTABLISHED 28 minutes ago, 9.4.6.2[9.4.6.2]...1.2.3.4[1.2.3.4]
Actions
Copy link
 #4

Updated by Jim Thompson over 10 years ago

  • Assignee set to Ermal Luçi
Actions
Copy link
 #5

Updated by Renato Botelho over 10 years ago

  • Status changed from New to Feedback
Actions
Copy link
 #6

Updated by Chris Buechler about 10 years ago

  • Status changed from Feedback to Resolved

fixed

Actions
Copy link

Also available in: Atom PDF