Regression #14965
closed
Input validation prevents saving DHCPv6 Relay settings
Added by Danilo Zrenjanin 6 months ago.
Updated 6 months ago.
Plus Target Version:
23.09.1
Affected Architecture:
All
Description
On the 23.09-RELEASE, DHCPv6 Relay won't start. Although the Upstream Servers field has a valid server address, it throws an error.
The error message:
The following input errors were detected:
The field Destination Server is required.
It worked fine on the previous version.
Files
the same behavior,
tested on
the same behavior,
tested on
23.09-RELEASE (amd64)
built on Tue Oct 31 22:56:00 MSK 2023
FreeBSD 14.0-CURRENT
I can also verify this behavior.
- Status changed from New to In Progress
- Assignee set to Marcos M
- Target version set to 2.8.0
- Plus Target Version set to 24.03
- Subject changed from ISC DHCPv6 Relay won't start to Input validation prevents saving DHCPv6 Relay settings
- Status changed from In Progress to Pull Request Review
- Affected Version set to 2.7.1
- Affected Architecture All added
- Status changed from Pull Request Review to Feedback
- % Done changed from 0 to 100
I tested the patch.
The error message "Destination Server is required" has been resolved, however, the service is still not starting.
Please check again.
Tested the patch and service is able to start
- Status changed from Feedback to Resolved
I tested again on a clean install and it indeed works fine.
I am marking this ticket resolved.
- Target version changed from 2.8.0 to 2.7.2
- Plus Target Version changed from 24.03 to 23.09.1
Also available in: Atom
PDF
Updated by 
Updated by 
Updated by 
Updated by 
Updated by