pfSense

06/27/2009

03:30 AM Bug #22 (Resolved): Problems with 1.2.x configuration restore to 2.0

There are at least two issues with restoring a configuration from 1.2.x onto 2.0. Ones noticed during one particular... Chris Buechler

03:29 AM Bug #21 (Resolved): Rulesets containing hostnames do not load at boot time

Rulesets in 2.0 containing hostnames does not load properly at boot time because the host names do not resolve. Chris Buechler

06/25/2009

04:51 AM Bug #20 (Resolved): net.inet.icmp.icmplim affects traffic passing

net.inet.icmp.icmplim has been reported to limit the amount of ICMP passing through FreeBSD/pfSense, not just destine... Chris Buechler

06/24/2009

08:50 PM Bug #19 (Closed): Console VLAN setup broken by VLAN changes

After changing from vlanX where X is the VLAN ID to a naming scheme including the parent interface name, the console ... Chris Buechler

06/23/2009

11:14 PM Bug #18 (Resolved): Link loss can cause multi-WAN difficulties

When you lose link on a NIC assigned as an OPT WAN, the static route that directs the monitor IP out the correct WAN ... Chris Buechler

06/22/2009

02:55 PM Feature #17: LED support on ALIX, WRAP, etc.

I see that there is already code which blinks on a pending alert, so that's already in and taken care of.
I'll pro... Jim Pingle

10:17 AM Feature #17 (Closed): LED support on ALIX, WRAP, etc.

There is now hardware support for LEDs on several embedded platforms, but there isn't much to do with them yet.
A ... Jim Pingle

06/21/2009

11:00 PM Bug #15: Package reinstall on configuration restore doesn't work

Upon further review, I may be remembering something else, not sure if this ever happened automatically. After restore... Chris Buechler

10:44 PM Bug #15 (Resolved): Package reinstall on configuration restore doesn't work

Not sure when this stopped working, in 1.2.3-RC1 official and current snapshots, when a configuration including packa... Chris Buechler

10:47 PM Bug #16 (Resolved): Deleting multiple OPT interfaces results in an invalid configuration

If you delete two OPT interfaces with the DHCP server enabled, you end up with a broken configuration.
XML error:... Chris Buechler

06/10/2009

09:47 PM Bug #14 (Resolved): reply-to should not be added when bridging

When bridging to a WAN or OPT WAN with hosts that use a gateway other than the WAN/OPT WAN's gateway, reply-to will b... Chris Buechler

11:18 AM Bug #3: VPN negation rules not added in 2.0

The idea is to check the phase2 networks and check them with every rule we add if route-to is defined and the src/dst... Ermal Luçi

11:14 AM Todo #5: Don't sync on every filter reload

This is already implemented. Ermal Luçi

11:12 AM Feature #8: Clear states after failover

I have done this for pppoe/pptp/l2tp interfaces through pfctl -b in 2.0.
For the other cases some more code analysis... Ermal Luçi

11:07 AM Bug #9: route-to forwards broadcast and multicast frames in some scenarios

Patch present for 8.0 FreeBSD more testing needed. Ermal Luçi

11:06 AM Bug #12: Editing DNS forwarder overrides does not trigger sync to secondary

This problem is fixed on 2.0 since we now do a sync when writing the config instead of filter reload. Ermal Luçi

06/09/2009

09:24 AM Feature #13 (Resolved): wireless page to have option to select transmit and receive antennas

in the wireless section this has been talked about and was said it would be added in future releases but nothing so f... Bipin Chandra

06/04/2009

01:38 AM Bug #12 (Resolved): Editing DNS forwarder overrides does not trigger sync to secondary

Editing any overrides (and possibly other settings) in the DNS forwarder should trigger a sync to the secondary if th... Chris Buechler

06/02/2009

11:05 PM Feature #11 (Resolved): Allow multiple syslog servers

Currently only a single syslog server can be specified, it would be nice to allow multiple servers. Chris Buechler